ACDelco 14587b | Rear Drum Brake Shoe
Special Price $29.74 Regular Price $34.99
Out of stock
ACDelco Silver (Advantage) Bonded Brake Shoes are a quality, high value alternative for General Motors vehicles as well as most makes and models and are backed by General Motors. These bonded brakes deliver strong braking power while reducing noise and vibration. The chamfer angle and vane configuration follow the OE design. Also no machining is required. ACDelco Silver (Advantage) Bonded Brake Shoes are ready to be installed right out of the box. ACDelco Silver (Advantage) parts are a good choice for many vehicles on the road today. Some ACDelco Silver parts may have formerly appeared as ACDelco Advantage. ?
WARNING: Cancer and Reproductive Harm - https://www.P65Warnings.ca.gov
- Available in riveted and bonded for various vehicle applications
- Basic shims, slots, and chamfers help to diminish noise, vibration, and braking harshness
- Economical value with dependable quality
- For General Motors vehicles as well as most makes and models
- Non-directional brake surface finish for consistent braking
- Quality validated for proper metallurgy and correct brake plate thickness
- Some ACDelco Silver parts may have formerly appeared as ACDelco Advantage
|Drum Inside Diameter (in)||9|
|FAQ - Answer 1||No, but it is a good idea to inspect your brake shoes at each tire rotation.|
|FAQ - Answer 2||Yes, it is a good idea to inspect your brake fluid often.|
|FAQ - Answer 3||No, but it is a good idea to inspect them for wear-out, cracking, leaking etc.|
|FAQ - Question 1||Do I have to replace my brake shoes after a certain amount of time?|
|FAQ - Question 2||Do I need to check my brake fluid when replacing other brake parts?|
|FAQ - Question 3||Do I have to replace all my brake parts when replacing my brake shoes?|
|Friction Material Attachment||Bonded|
|Good Maintenance Practices - Section 1 - Bullet 1||Check brake fluid level at every oil change. Replace fluid according to owner's manual recommendations.|
|Good Maintenance Practices - Section 1 - Bullet 2||Calipers and wheel cylinders should be checked every brake inspection and serviced or replaced as required.|
|Good Maintenance Practices - Section 1 - Bullet 3||Inspect the brake lines for rust, punctures, or visible leaks (You may be able to do this, but consult a qualified technician if necessary).|
|Good Maintenance Practices - Section 1 - Header||The following inspections and maintenance procedures can help prevent potential brake problems:|
|Good Maintenance Practices - Section 2 - Bullet 1||Inspection of the brake hoses for brittleness or cracking.|
|Good Maintenance Practices - Section 2 - Bullet 2||Inspection of brake lining and pads for wear or contamination by brake fluid or grease.|
|Good Maintenance Practices - Section 2 - Bullet 3||Inspection of wheel bearings and grease seals.|
|Good Maintenance Practices - Section 2 - Bullet 4||Parking brake adjustments (as needed).|
|Good Maintenance Practices - Section 2 - Header||The following should be conducted by a qualified technician:|
|Mounting Hardware Included||No|
|Primary Shoe Friction Material Length (in)||9|
|Primary Shoe Friction Material Length (mm)||228.6|
|Secondary Shoe Friction Material Length (in)||9|
|Secondary Shoe Friction Material Length (mm)||228.6|
|Signs of Wear & Troubleshooting - Section 1 - Bullet 1||Brake pedal pulsation (not to be confused with normal ABS operation).|
|Signs of Wear & Troubleshooting - Section 1 - Bullet 2||Squealing or grinding noises.|
|Signs of Wear & Troubleshooting - Section 1 - Bullet 3||Low brake pedal height.|
|Signs of Wear & Troubleshooting - Section 1 - Bullet 4||Vehicle pulls to the left or right when brakes are applied.|
|Signs of Wear & Troubleshooting - Section 1 - Header||Brake shoe signs of wear include:|
- 2005-2006 Toyota Camry - Position: Rear
- Japan Built Vehicle Superseded by 17587B
- 1999-2003 Toyota Solara - Position: Rear
- Superseded by 17587B
- 1996-2002 Toyota RAV4 - Position: Rear
- Superseded by 17587B
- 1987-2003 Toyota Camry - Position: Rear
- Superseded by 17587B
- 2004-2004 Toyota Camry - Position: Rear
- Thru 5/04 Superseded by 17587B
Does AC Delco make Ford parts?
No, AC Delco produces parts primarily for General Motors vehicles and does not make parts specifically for Ford vehicles.
Can I use AC Delco parts to replace OEM parts?
Yes, in most cases AC Delco parts can be used as a replacement for OEM parts. However, it's important to ensure that the parts are compatible with your specific make and model of vehicle.
What AC Delco oil filter do I need?
AC Delco offers a variety of oil filters that are compatible with different makes and models of vehicles. To determine which AC Delco oil filter you need, consult your vehicle's owner's manual or use our online filter lookup tool that matches the make, model, and year of your vehicle.
How often should I have a brake replacement done?
As a general guideline, it is recommended to have your brakes inspected at least once a year or every 12,000 to 15,000 miles.
How often should brake pads be replaced in a typical car?
Brake pads in a typical car should be replaced approximately every 30,000 to 70,000 miles, but the replacement interval can vary depending on driving habits, vehicle type, and brake pad material.