GM Genuine Parts Brake Hydraulic Lines are designed, engineered, and tested to rigorous standards, and are backed by General Motors. These are quality reinforced lines that carry fluid within the brake system. The hydraulic fluid must travel to the wheel brakes from the master cylinder. It does this through brake lines or pipes and brake hoses. Brake lines and hoses are designed to withstand high pressures. GM Genuine Parts are the true OE parts installed during the production of or validated by General Motors for GM vehicles. Some GM Genuine Parts may have formerly appeared as ACDelco GM Original Equipment (OE).

• Some GM Genuine Parts may have formerly appeared as ACDelco GM Original Equipment (OE)
• GM Genuine Parts are designed, engineered and tested to rigorous standards, and are backed by General Motors
• GM Engineers design and validate OE parts specifically for your Chevrolet, Buick, GMC, or Cadillac vehicle
• GM regularly updates production and service part designs to integrate new materials and technologies

Bendable:	No
End 1 Flare Type:	Bubble
End 1 Thread Diameter:	0.47
End 1 Thread Diameter:	12
End 2 Flare Type:	Bubble
End 2 Thread Diameter:	0.55
End 2 Thread Diameter:	14
Fitting Finish:	Zinc
Fitting Material:	Steel
Fitting Type:	Flared Tube Nuts
Height (in):	5.3
Length (in):	26.4
Line Diameter:	0.24
Line Diameter:	6
Line Length:	38.46
Line Length:	977
Line Material:	Steel and Rubber
Meets or Exceeds Original Equipment Manufacture Specifications:	Yes
Outer Spring:	No
Outer Wear Guard:	No
Polyvinyl Fluoride Coated:	No
Pre-Formed:	Yes
Programming Required:	No
Teflon Lined:	No
Weight (lb):	0.38
Width (in):	6.8

• 2000-2003 Buick LeSabre | Position: Rear At Master Cylinder
• 2000-2003 Cadillac DeVille | Position: Rear At Master Cylinder
• 2000-2003 Pontiac Bonneville | Position: Rear At Master Cylinder
• 2001-2003 Oldsmobile Aurora | Position: Rear At Master Cylinder