Part Number
20-6182
$88.99
Out of stock
CARDONE Remanufactured Power Steering Pumps are engineered to meet or exceed O.E. performance. Original designs are scrutinized for potential improvement, and where applicable, design upgrades are implemented to produce a more durable part than the original. All critical components are tested to ensure proper function. Every unit undergoes a hydraulic efficiency test to ensure reliable, long-lasting performance.
BRAND: Cardone Reman
FEATURES:
- Buick Skylark 1969-68, Special 1969-68; Chevrolet Bel Air 1974-71 1969-65, Biscayne 1972-71 1969-65, Blazer 1973, Brookwood 1972-71 1969, C10 Suburban 1974-73, C20 Suburban 1974-73, Camaro 1969-67, Caprice 1974-71 1969-67, Chevelle 1973-64, Chevy II 1968,
- Power Steering Pump
- Power Steering Pump, Steering Pump, Pump and Reservior
- Reman. Power Steering Pump
- Remanufactured Power Steering Pump
SPECIFICS:
E-Waste | No |
FAQs | Should I ever change my fluid, even though nothing is wrong? |
FAQs | Why is the pump making a whining noise all of the time? |
FAQs | Most likely cause is contamination. Remove the pressure hose and pressure fitting on the power steering pump. Remove the flow control valve and spring. Clean the valve and check the valve bore for damage. Reinstall the spring, valve, fitting and hose. Flush and bleed system and re-test. If okay, install power steering filter to prevent problem from re-occurring. |
FAQs | The problem is most likely in the steering unit-the pump does not know left from right. Check for binding steering components and repair as necessary. |
FAQs | Why do I still have hard steering in one direction after I replaced the pump? |
FAQs | I bought a replacement power steering pump and my original pulley has a loose fit on the replacement pump shaft. What should I do? |
FAQs | I only have assist when increasing engine rpm after installing the replacement pump. What's causing this? |
FAQs | The pulley may have cracked upon removal. If the shaft was mushroomed before removing the pulley, it has now enlarged the bore in the pulley. The pulley must be replaced. |
FAQs | Yes. Some O.E. manufacturers recommend that power steering fluid be changed at 50,000 miles and continue at that interval. Just like engine oil, power steering fluid will eventually break down and carry suspended contaminants from component wear and breakdown. Follow your vehicle's O.E. manufacturer's recommendations on fluid change intervals. |
FAQs | A whining pump is usually caused by air in the system. Remove reservoir lid and inspect fluid level and condition. If fluid has foam or air bubbles present, you must bleed the system again. Some systems are very difficult to bleed manually and may require the use of a vacuum pump to extract all of the air from the system. |
Features and Benefits | Units are supplied with 100% tested and calibrated pressure relief valves. |
Features and Benefits | Shafts are surfaced to precise specifications to eliminate premature seal wear and extend pump life. |
Features and Benefits | All critical components (cam packs, spool valves, etc.) are triple-tested to ensure product reliability. |
Features and Benefits | As a remanufactured Original Equipment part, this unit guarantees a perfect vehicle fit. |
Features and Benefits | Our remanufacturing process is earth-friendly, as it reduces the energy and raw material needed to make a new part by 80%. |
Features and Benefits | FInal pump assembly is computer-tested to measure pressure, bypass, fluid flow, valve operation, steering effort and noise to ensure reliable performance. |
Features and Benefits | All units are built with 100% new O-rings and premium-grade HNBR seals to prevent leaks. HNBR does not break down at high temperatures like conventional seal material. |
Hose Port Type | Seat |
Housing Material | Cast Iron |
Mounting Hardware Included | No |
Package Contents | Hydraulic Pump; Instruction Sheet |
Power Steering Outlet ID Size | 0 |
Power Steering Outlet Thread Size | 5/8-18 |
Power Steering Pump Inlet Attachement Type | Hose Barb |
Power Steering Pump Outlet Attachment Type | Threaded |
Power Steering Pump Outlet Quantity | 1 |
Power Steering Reservoir Cap Included | No |
Product Condition | Remanufactured |
Pulley Attachement Type | Bolt-On |
Pulley Included | No |
Remote Reservoir | No |
Reservoir Included | Yes |
APPLICATIONS:
- 1965-1969 Chevrolet Biscayne
- 1973-1973 Pontiac GTO
- 1971-1974 Chevrolet Caprice
- 1974-1974 Chevrolet K10 Pickup
- 1971-1972 Chevrolet Brookwood
- 1971-1972 Chevrolet Kingswood
- 1966-1969 Chevrolet Impala
- 1967-1969 Chevrolet Caprice
- 1973-1974 Chevrolet C20 Suburban
- 1969-1969 Chevrolet Brookwood
- 1971-1974 Chevrolet Bel Air
- 1973-1974 Pontiac Bonneville
- 1971-1974 Chevrolet Monte Carlo
- 1971-1974 Chevrolet Impala
- 1968-1969 Buick Special
- 1973-1974 Chevrolet K20 Pickup
- 1973-1974 Pontiac Grand Am
- 1964-1967 Chevrolet Malibu
- 1973-1974 GMC C15/C1500 Suburban
- 1971-1974 Chevrolet El Camino
- 1973-1974 GMC K25/K2500 Pickup
- 1964-1969 Chevrolet El Camino
- 1969-1969 Chevrolet Nova
- 1973-1974 Pontiac Grand Safari
- 1973-1973 GMC Jimmy
- 1973-1974 Chevrolet Malibu
- 1971-1972 Chevrolet Biscayne
- 1973-1974 Pontiac Grandville
- 1973-1974 Pontiac LeMans
- 1973-1974 Chevrolet K30 Pickup
- 1973-1974 GMC K35/K3500 Pickup
- 1971-1974 GMC Sprint
- 1968-1969 Oldsmobile Cutlass
- 1973-1974 Pontiac Catalina
- 1973-1974 Chevrolet Laguna
- 1968-1969 Buick Skylark
- 1965-1969 Chevrolet Bel Air
- 1964-1973 Chevrolet Chevelle
- 1967-1969 Chevrolet Camaro
- 1968-1968 Chevrolet Chevy II
- 1968-1969 Oldsmobile F85
- 1973-1974 Chevrolet C10 Suburban
- 1973-1973 Chevrolet Blazer
- 1969-1969 Chevrolet Kingswood
- 1971-1972 Chevrolet Townsman
- 1973-1973 Chevrolet K20 Suburban
Customer Questions
Compatible Vehicles
Year
Make
Model
Engine