Straight Pipe Cat-Back Exhaust System; 2.5 in.; Incl. Pipes/4 in. x 8 in. Single Round Rolled Angle-Cut Lined Tips; Split Rear Exit;

A Borla 'Axle Back' or rear section exhaust implies the exhaust system is located behind the vehicle rear axle . Most installations are completed in less than an hour and require no cutting of the factory system. A Borla Axle Back performance exhaust is a less restrictive aftermarket exhaust system that will improve the sound level both inside the cabin and exterior. Borla Axle Back exhaust systems use engine-specific (not universal) mufflers that are designed, tested, and optimized specifically for a particular year/make/model vehicle.

• Made From High-Quality T-304 Austenitic Stainless Steel
• Mandrel Bent Pipes
• Ensures Consistent Diameter Through Each Curve
• Mufflers Have No Baffles/Chambers
• Produces High Velocity
• Million Mile Warranty

Exhaust Type:	Axle-Back
Exit Position:	Split Rear
Inlet Inside Diameter:	2.500 in.
Material:	Stainless
Tail Pipe Diameter:	2.500 in.
Tip Diameter:	4.000 in.
Tubing Diameter:	2.500 in.
WARNING CA Proposition 65:	Yes
WARNING CA Proposition 65 Message:	WARNING: This product in the physical form it is sold does not present a hazard. However; operations including; but not limited to welding; brazing; or thermal cutting can expose you to chemicals including Chromium; Nickel; Cobalt; Arsenic; Cadmium and Lead which are known to the State Of California to cause cancer; birth defects and other reproductive harm. For more information go to www.P65Warnings.ca.gov

• 1997-2004 Chevrolet Corvette        Note: 2.5 in.; Incl. Pipes/4 in. x 8 in. Single Round Rolled Angle-Cut Lined Tips; Split Rear Exit;50 State Legal / California Emissions Compliant;T-304 Stainless Steel