Mallory 605 | Ignition Control Module

Replacement UNILITE module. For all MALLORY UNILITE distributors, and Conversion Kits. Requires a 1.4ohms Ballast resistor, Loom resistor, or internally resisted coil. Also can replace the ACCEL Point Eliminator kit module. Come with new connector, grommet, wire tie, screws, and heat sink grease. Only the UNILITE module will fire below 75 RPM. This module is very accurate. It will also trigger at a lower or higher RPM than any other module on the market.

• Holley Performance Emission Code 4: This part is legal for sale or use on Racing Use Only Vehicles. The following vehicles are considered Racing Use Only Vehicles: Racing Use Only Vehicles are vehicles that are used exclusively for competition that are not registered and that may never be used on the street. WARNING: It is against the law to install this part on an Emissions Controlled Vehicle
• Replacement UNILITE module. For all MALLORY UNILITE distributors; and Conversion Kits. Requires a 1.4ohms Ballast resistor; Loom resistor; or internally resisted coil. Also can replace the ACCEL Point Eliminator kit module. Come with new connector; grommet; wire tie; screws; and heat sink grease. Only the UNILITE module will fire below 75 RPM. This module is very accurate. It will also trigger at a lower or higher RPM than any other module on the market.
• Unilite Ignition Module
• This Module Is Very Accurate
• Unilite Ignition Module; Thermaclad; For All Mallory Unilite Distributor And Conversion Kits;
• Easy Installation
• Will Fire Below 75 RPM
• Will Trigger At A Lower Or Higher RPM

INSTALLATION INSTRUCTIONS