An ACDelco Professional Remanufactured Distributor is a high quality replacement for many vehicles on the road today. It is an assembly that contains a switching device, distributor cap, distributor rotor, and distributor shaft. The switching device or sensor provides the signal to switch the ignition coil primary circuit ON and OFF at the correct moment. Remanufacturing the distributor is an industry standard practice that involves disassembly of existing units, and replacing components that are most prone to wear with new components. Damaged and obsolete parts are replaced and are end of line tested to ensure they perform to ACDelco specifications. In addition, remanufacturing returns components back into service rather than processing as scrap or simply disposing of them. This premium aftermarket replacement component will provide the same performance, durability, and service life you expect from ACDelco.

• This part requires programming and/or special setup procedures. GM Service Information describes the procedures and special tools needed to ensure proper operation in the vehicle
• Some ACDelco GM Original Equipment parts may have formerly appeared as GM Genuine Parts (OE) or ACDelco Professional
• Remanufacturing is an industry standard practice that returns parts into service rather than scrapping them
• Tested to ensure they perform to GM specifications

Height (in):	9.62
Length:	14.38
Programming Required:	Yes
Weight (lb):	1.9
Width (in):	10

• 1992-1994 Chevrolet Corvette
• 1993-1994 Chevrolet Camaro
• 1993-1994 Pontiac Firebird