ACDelco GM Original Equipment Oxygen (O2) Sensors are special feedback sensors on your vehicle's exhaust system, and are GM-recommended replacements for your vehicle's original components. These sensors measure the proportion of oxygen in exhaust gases. Using this measurement, the engine control module (ECM) can adjust the air/fuel ratio to near the optimal value of 14.7:1. At this ratio, engine performance, emissions, and fuel economy are all optimized. These original equipment oxygen sensors have been manufactured to fit your GM vehicle, providing the same performance, durability, and service life you expect from General Motors.

• Detects oxygen content in the exhaust gases to help optimize emissions
• GM-recommended replacement part for your GM vehicle's original factory component
• Offering the quality, reliability, and durability of GM OE
• Manufactured to GM OE specification for fit, form, and function

Connector Gender:	Male
Connector Shape:	Round
Height (in):	3.03
Length (in):	17.3
Length (mm):	439.5
Mounting Type:	POSN 1
Programming Required:	No
Sensor Type:	Non Heated
Thread Diameter:	18
Universal Or Specific Fit:	Specific
Weight (lb):	0.21
Width (in):	3.03
Wire Quantity:	1
Wiring Harness Length:	357

• 1999 Chevrolet Cavalier        Position: Upstream        Note: IN EXH MANIFOLD/CROSSOVER
• 1999 Chevrolet Malibu        Position: Upstream        Note: IN EXH MANIFOLD/CROSSOVER
• 1999 Oldsmobile Alero        Position: Upstream        Note: IN EXH MANIFOLD/CROSSOVER (RC9)
• 1999 Pontiac Grand Am        Position: Upstream        Note: IN EXH MANIFOLD/CROSSOVER (RC9)
• 1999 Pontiac Sunfire        Position: Upstream        Note: IN EXH MANIFOLD/CROSSOVER