Engine Control Module

CARDONE Remanufactured Electronic and Powertrain Control Modules are designed to meet or exceed O.E. performance. Reverse engineering provides insight into how and why the unit originally failed, allowing our engineers to identify and correct original design weaknesses. All critical components are re-soldered or replaced at our Philadelphia manufacturing plant, and each unit is 100% computer tested to ensure reliability. CARDONE is committed to getting your vehicle back to peak performance.

• Tested with automated computer equipment or bench-tested, depending on application, to ensure functionality.
• Re-soldering of critical components ensures superior electrical connections. This prevents intermittent failures and leads to longer product life.
• On-car vehicle validation is done to test durability and performance.
• As a remanufactured Original Equipment part, this unit guarantees a perfect vehicle fit.
• Our remanufacturing process is earth-friendly, as it reduces the energy and raw material needed to make a new part by 80%.

Connector Quantity:	1
Connector Shape:	Rectangle
E-Waste:	Yes
FAQs:	Chrysler PCM's identified with a "V" suffix will need to be vin programmed.
FAQs:	Do all Chrysler Power Train Control Modules (PCM) need vin programming?
FAQs:	Do all Ford vehicles require a Passive Anti Theft System (P.A.T.S) reset?
FAQs:	I replaced the PCM in my GM vehicle. Do I need to reset the Passlock or Passkey Vehicle Anti Theft System (VATS)?
FAQs:	No, not all Ford vehicles require a PATS reset. Check the PATS chart found on the MotorCraft Site for your application.
FAQs:	Prior to replacing the original ECM/PCM, the installer should determine what caused the original to fail. Common areas that cause failures are: poor grounds and powers, bad wiring harness, shorted solenoids/relays.
FAQs:	The replacement ECM for a Ford vehicle wonGÇÖt start the vehicle. Why?
FAQs:	The wrong ECM may have been installed. Verify the Ford Engineering Id number, found on the ECM/PCM, crosses to the correct CARDONE number.
FAQs:	What steps should I take to assure the original ecm/pcm is causing the issue?
FAQs:	Yes, there's a 10 minute procedure utilizing a Tech 2 Scanner and a GM Terminal Subscription. There is also a 30 minute manual procedure that can be done without a scanner. Refer to an OE approved service manual for either option.
Features and Benefits:	As a remanufactured Original Equipment part, this unit guarantees a perfect vehicle fit.
Features and Benefits:	On-car vehicle validation is done to test durability and performance.
Features and Benefits:	Our remanufacturing process is earth-friendly, as it reduces the energy and raw material needed to make a new part by 80%.
Features and Benefits:	Re-soldering of critical components ensures superior electrical connections. This prevents intermittent failures and leads to longer product life.
Features and Benefits:	Tested with automated computer equipment or bench-tested, depending on application, to ensure functionality.
Flash Programming Required:	No
Flashable:	No
Housing Material:	Plastic
Mounting Hardware Included:	No
Mounting Hole Quantity:	3
Product Condition:	Remanufactured
Removable PROM:	No
Terminal Quantity:	60
Terminal Type:	Pin|Male

• Dodge: 53008933

• 1991 Dodge B250
• 1991 Dodge B350
• 1991 Dodge D150
• 1991 Dodge W150
• 1991 Dodge W250
• 1991 Dodge B150
• 1991 Dodge D250
• 1991 Dodge Ramcharger