Mallory 6100M | Ignition Control Module

Replacement E-SPARK module. For all MALLORY UNILITE distributors, and Conversion Kits. Requires a 1.4 ohms Ballast resistor, Loom resistor, or internally resisted coil. Also can replace the ACCEL Point Eliminator kit module. Includes new connector, grommet, wire tie, screws, and heat sink grease.

• Replacement E-SPARK module. For all MALLORY UNILITE distributors; and Conversion Kits. Requires a 1.4 ohms Ballast resistor; Loom resistor; or internally resisted coil. Also can replace the ACCEL Point Eliminator kit module. Includes new connector; grommet; wire tie; screws; and heat sink grease.
• E-Spark Ignition Control Module
• Easy Installation
• E-Spark Ignition Control Module; LTS Module; Thermaclad;
• Replace UNILITE Or ACCEL Point Eliminator modules
• Holley Performance Emission Code 4: This part is legal for sale or use on Racing Use Only Vehicles. The following vehicles are considered Racing Use Only Vehicles: Racing Use Only Vehicles are vehicles that are used exclusively for competition that are not registered and that may never be used on the street. WARNING: It is against the law to install this part on an Emissions Controlled Vehicle

INSTALLATION INSTRUCTIONS