Service and Maintenance

The installation process for Warn parts will vary depending on the specific part and the make and model of your vehicle. Generally, you'll need to review the manufacturer's instructions, prepare your vehicle, install the part according to the instructions, and test the part to ensure it's working properly.

Yes, in most cases AC Delco parts can be used as a replacement for OEM parts. However, it's important to ensure that the parts are compatible with your specific make and model of vehicle.

AC Delco offers a variety of oil filters that are compatible with different makes and models of vehicles. To determine which AC Delco oil filter you need, consult your vehicle's owner's manual or use our online filter lookup tool that matches the make, model, and year of your vehicle.

To install Energy Suspension bushings, remove old bushings, press or tap in new bushings using a bushing installation tool, clean and lubricate suspension components, and follow specific instructions provided by Energy Suspension.

As a general guideline, it is recommended to have your brakes inspected at least once a year or every 12,000 to 15,000 miles.

If you experience brake squealing, it is recommended to have your brakes inspected by a qualified technician as soon as possible to determine the cause and address any potential issues.

Signs of a malfunctioning caliper on a car may include uneven brake pad wear, reduced braking performance, pulling or veering to one side during braking, and visible brake fluid leakage.

Brake pads in a typical car should be replaced approximately every 30,000 to 70,000 miles, but the replacement interval can vary depending on driving habits, vehicle type, and brake pad material.

An engine oil filter works by removing contaminants and impurities from the engine oil as it circulates through the engine, ensuring cleaner oil reaches critical engine components.

The purpose of a bumper in a car is to absorb and distribute impact energy during collisions, protecting the vehicle's occupants and reducing damage to the vehicle's structure.

Yes, B&W hitches can rust over time if not properly maintained.

Yes, a serpentine belt can cause smoke. A serpentine belt is an essential component of a vehicle's engine system. It drives various accessories such as the alternator, power steering pump, water pump, and air conditioning compressor. If the serpentine belt becomes worn, damaged, or misaligned, it can cause friction and generate smoke.

To install a Bestop Sunrider, you typically need to remove the factory hardtop or soft top, attach the Sunrider frame, install the fabric, and secure it in place.

The serpentine belt can squeal due to various reasons, including tension issues, worn-out belt, or a problem with the belt's pulleys.

The engine coolant thermostat should be replaced if it is not functioning properly or as a preventive maintenance measure after a certain mileage or time interval.

Yes, there are maintenance and servicing requirements for Fox Shocks to ensure optimal performance and longevity.

In most cases, a malfunctioning engine coolant temperature sensor (ECT sensor) will not prevent the car from starting. The engine coolant temperature sensor (ECT sensor) is responsible for monitoring the temperature of the engine coolant and sending that information to the engine control unit (ECU). The ECU uses this information to make adjustments to the fuel mixture and ignition timing for optimal engine performance.

Yes, there are specific maintenance and installation guidelines to follow when using Gates products to ensure optimal performance and longevity.

No, K&N filters should not get wet.

K&N air filters should be cleaned approximately every 50,000 miles (80,000 kilometers) or as recommended by the manufacturer.